Skip to main content

Search This Blog

Energy Tab

BHEL make 500 MW

Posts

Showing posts from September, 2018

X-CURVES

Get link
Facebook
X
Pinterest
Email
Other Apps

September 02, 2018

Ash Handling system Part-II

Get link
Facebook
X
Pinterest
Email
Other Apps

September 02, 2018

Powered by Blogger

Theme images by Maliketh

Report Abuse

Translate

Popular posts from this blog

HP & LP Bypass Operation and Protection

HP & LP Bypass Operation and Protection Purpose Boiler operation independent of the turbine Minimum steam flow through SH & RH tubes during start-ups, low load operation & sudden unloading of unit Utilized or building up of steam parameters Avoiding the boiler trip on Reheat protection No steam flow through Boiler steam tubes will lead to starvation & thereby overheating and lead to premature failure of tubes The capacity of HPLP bypass is 60% of full load turbine steam flow Reheat Protection: RH protection (delay=10 sec) will act if TURBINE HP V/V & HPBP CLOSED [ either turbine HP stop v/v or HP CV in both HP line closed ] & [ both HP BP <2%] OR TURBINE IP V/V & LP BP closed [ Either IP stop v/v or IP CV v/v in both IP line closed ] & [ Either LP BP stop v/v or LP BP C/V in both LP line is closed] OR Generator ckt bkr open & [both HP BP closed OR both L...

Generator Air Tightness Test

December 25, 2017

Generator Air Tightness Test Period Of Test= 24 Hrs without a Break Air Pressure Drop (Allowed in 24 Hrs) : <=0.15 ksc Air Test Pressure = 3.5 ksc All LLDs Drain Closed. Ensure Seal Oil system in Operation Seal Oil DP >1.5 ksc AS Seal Oil Pr>4.5 ksc, start H2S Seal Oil system H2 Cooler Isolated PW in Winding is in filled condition, Winding Isolated. PW also kept Isolated. PW Tank at Atmospheric Pressure Ensure availability of Instrument air and Bleed Out moisture from it by keeping it open till Connect flexible air hose with the gas plant through the coupling and ensure no air leakage is there The filling is to be done by opening the valves in the normal H2 filling line where as the valve from H2 rack side will remain closed. Once the air filling is commenced the test record data sheet The air valve is to be opened full. While pressurising the LLD / Seal oil DP / Seal oil parameters are to be recorded as per the enclosed sheet. The...

Turbine and TDBFP Overspeed & Oil Injection Test Procedure

December 10, 2019

Oil Injection of Main Turbine: Press Test Valve Turn Test Hand-wheel Anticlockwise slowly ( to develop Test Oil) Note Turbine Speed, Test Oil Pressure, Primary Oil Pressure when Bolts Operate(Aux Trip Oil becomes 0) Turn Test Hand-wheel Clockwise slowly (Test Oil pressure becomes 0)

Archive

February 20242
January 20249
October 20231
July 20231
May 20232
October 20221
July 20201
June 20205
May 202013
January 202011

December 201926
November 201910
December 201811
November 20181
October 201817
September 20182
August 20181
May 201819
March 20187
February 201814
January 20185
December 20172
November 201745
October 201714

Show more Show less